PX-700Multi-RoomAudio Controller2/2002, rev 2.0HardwareInstallation Manual®
Rear PanelSOURCE CONNECTIONS (RCA connectors)PAGE IN/OUT (RCA connectors)For use with paging systems.ZONE6 TAPE OUT(RCA connectors)IR IN/OUT (mono 1⁄8
Section 2Quick-Start GuideYou Will Need ❑ PX-700(s)❑ KPS(s), ATC(s)❑ KPT(s)❑ Amplification❑ Speakers❑ Source Equipment❑ A supply of IR Emitters (not f
☞The following three conventions apply to Zone and Room definitions:ZoneA Zone is an area of an Installation that accesses a source independentlyfrom
The PX-700 must be very well ventilated. Be sure to provide for this wheninstalling each unit and in designing of any cabinetry for the Installation.P
Example APD 1D 2GPD 1D 2GPD 1D 2GPD 1D 2GPD 1D 2GPD 1D 2GPD 1D 2GKPTPWRData 1Data 2GNDPD 1D 2GPD 1D 2GPD 1D 2GPD 1D 2GPD 1D 2GPD 1D 2GPD 1D 2GKPTPX-70
Example BPD 1D 2GPD 1D 2GPD 1D 2GPD 1D 2GPD 1D 2GPD 1D 2GPD 1D 2GKPTPWRData 1Data 2GNDPD 1D 2GPD 1D 2GPD 1D 2GPD 1D 2GPD 1D 2GPD 1D 2GPD 1D 2GKPTPX-70
Audio ➤ To connect audio sources, use regular RCA cables to connect sources to theleft and right SOURCE IN jacks on the rear panel of the first PX-700
Paging ➤ To connect a Page/Doorbell Module to a multi PX-700 system, parallel theMute Out from the PDM to the Page Trigger of each PX-700. To parallel
2.8(this page is intentionally blank)
Section 3Physical InstallationSource EquipmentAC PowerUse the Switched Outlet to provide power to source equipment wheneverpossible, because the PX-70
©Copyright 2002 Madrigal Audio LaboratoriesAll rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transm
on the power conductors due to the wire resistance and the current con-sumption of the connected device. Heavier wire will have lower resistance,there
Avoid splices. This will save time and prevent problems in general. However,if you must splice a cable, do not bury the splice! Make sure it will beac
In multiple PX-700 Installations, each PX-700 in the Installation shouldhave a dedicated KPT so that the keypads are not all powered from the same uni
4. Connect the Cat 5 cable to the ATC RS-232 Interface Board and therear of the ATC.5. Run 4-conductor wire from the keypad connector on the ATC RS-
Length of ATC ➤Cable RunsThe resistance of the cable and the voltage of the power supply to the ATCdetermine the maximum cable length. The ATC requir
At the ATC RS-232 Interface BoardMethod 1 (preferred)Use this method when powering the ATC from an AC to DC adapter.1. Make a pigtail with a short len
Audioaccess remote controllers and decode them at the keypad. Controldata is then sent to the PX-700. No actual IR signal is transmitted to the PX-700
System SwitchesFor a single PX-700 Installation, the System Code should be set to “1”(switch 5 up). In a multi PX-700 system, the System Code on the k
DIP Switch Settings for IRSwitch #9 controls the keypad IR receiver. In the “down” position it is ON,in the “up” position it is OFF. When a keypad is
Expansion Outputs (Fixed)These are secondary, fixed, unity gain outputs for each Zone which arespecifically designed for connection to an MA-361 Twelv
iiiImportant Note: This product is equipped witha single pole power switch that disconnects onlythe line side of the AC supply. The AC supply isnot co
The factory default for the ALL output is as an emitter. To connect ablaster-type IR emitter to the ALLjack do the following:➤ Disconnect the AC power
➤ If the trigger is active when the last Zone is turned off, the PX-700will not execute the Last Zone Off macro. ➤ If no Zones are on in the PX-700 In
RS-232 PortThis port enables direct connection of other RS-232 command systems tothe PX-700 or connection to a PC for IR and system programming. Thepr
Section 4System OperationThe Audioaccess keypads, touchscreens and IR remote controllers are an integral part of a PX-700 system.They are, largely, th
Audioaccess Remote ControllersPowerTo turn on a single Zone, momentarily press the keypad ON button (orON/OFF button on remote control) to turn on the
Volume ▲/▼ To increase the volume, press ▲. To decrease the volume, press ▼. MuteTo mute the audio on a KPS and KP-3 keypad, press ▲ and ▼ together. T
4.4(this page is intentionally blank)
Section 5Technical SpecificationsSpecifications Note: Due to constant research, specifications are subject to change without notice.Audio ➤❑Connector
Power Inlet ➤❑Connector: Male IEC320❑Power Requirement: 115V AC, 50/60Hz, 50 Watts (not includingswitched outlet)*Switched Outlet ➤❑Connector: NEMA 5-
A.1Appendix ABlock DiagramsOn the following pages you will find examples of four different block diagrams using the PX-700 andother Audioaccess produc
ivTable of ContentsContents PageImportant Safety Precautions __________________________________ iiiTypographical Conventions__________________________
Block Diagram 3Multi-Room audio system configured with 6 Primary Rooms and 6 Expansion Rooms.Audioaccess products include:❑ 1 PX-700 Multi-Room Contro
Block Diagram 1PX-700ZONE 1: PRIMARY ROOMLIBRARYZONE 2: PRIMARY ROOMGUEST ROOMZONE 3: PRIMARY ROOMCHILD'S ROOMZONE 4: PRIMARY ROOMMAS
APPENDIX A A.4Block Diagram 2PX-700ZONE 1: PRIMARY ROOMLIBRARYZONE 2: PRIMARY ROOMGUEST ROOMZONE 3: PRIMARY ROOMCHILD'S ROOMZONE 4:
Block Diagram 3ZONE 1: PRIMARY ROOMMASTER BEDROOMZONE 2: PRIMARY ROOMKITCHENZONE 3: PRIMARY ROOMLIBRARYZONE 4: PRIMARY ROOMGUEST SUITEZONE
Block Diagram 4PX-700ZONE 1: PRIMARY ROOMLIBRARYZONE 2: PRIMARY ROOMGUEST ROOMZONE 3: PRIMARY ROOMCHILD'S ROOMZONE 4: PRIMARY ROOMMAS
LIMITED WARRANTY(Applicable within United States and Canada)AUDIOACCESS®warrants to the original purchaser, this product to be free from defective mat
Madrigal Audio Laboratories, Inc.2081 South Main Street, P.O. Box 781Middletown, CT 06457 USATelephone: (860) 346-0896Fax: (860) 346-1540www.madrigal.
vTABLE OF CONTENTSKP3 Wiring_______________________________________________ 3.7MA-361, VX-241 and PX-603 Wiring __________________________ 3.7Keypad I
viTypographical ConventionsPlease note the following typographical conventions used throughout this manual.❑ Warnings that relate to user safety are h
Section 1PX-700 Product DescriptionDescription The PX-700 Multi-Room Controller is a six zone, multi-room, multi-sourceaudio system controller that is
Installation Manager uses standard control features found in all Windowsapplications: right mouse clicks, drag and drop, and pop up menus.Diagnostic t
Front Panel SYSTEMCODE SWITCH(Momentary switch accessible through panel)LED (Bi-color: red when power is applied, green when any zone is on)The front
Comments to this Manuals